Made to Fit FORD 12 VOLT CONVERSION KIT 2000 3000 4000 600 700

FORD 12 VOLT CONVERSION KIT 2000 3000 4000 600 700. This is a Brand New 12 volt Alternator Conversion Kit with which you can convert the original Ford 6 Volt System of your tractor to 12 Volts. Ford / New Holland TRACTOR: 2000 (w/ 4 cyl Engines) Ford / New Holland TRACTOR: 3000 (w/ 4 cyl Engines) Ford / New Holland TRACTOR: 4000 (w/ 4 cyl Engines) Ford / New Holland TRACTOR: 600 SERIES (w/ 4 cyl Engines) Ford / New Holland TRACTOR: 700 SERIES (w/ 4 cyl Engines) Ford / New Holland TRACTOR: 800 SERIES (w/ 4 cyl Engines) Ford / New Holland TRACTOR: 900 SERIES (w/ 4 cyl Engines). Includes: Alternator 12 volt 42 amp 1 wire, Resistor, Wiring Harness, Hardware Kit, 2 Bracket, Pulley, Belt, Assembly Instructions. Alternator Kit Installation Instructions 1.

Disconnect Battery Cables from the Battery in the tractor. Remove the existing generator, voltage regulator, mounting brackets and wiring necessary for this installation. Next the Alternator can be installed. The wiring harness now can be installed. Notice the routing diagram on the next page.

Next install a 12 Volt Battery - It must be installed as NEGATIVE Ground. All lights MUST be changed to 12V bulbs. Check to see if there is power at the Battery Terminal on the back of the Alternator. This should be Hot all the time. Now start the tractor and increase engine speed until the alternator starts charging. It may be necessary to go to full throttle to attain engine charge. If the alternator does not charge, re-check all steps. If manual excitation of the alternator is necessary, momentarily feed battery power to the #1 terminal in the plug (remove the plug cover) using a jumper wire attached to the alternator battery stud. Our ordering system is automated.

MyTractor carries a full line of tractor parts, accessories , decals , emblems and I&T Shop Service Manuals for most makes and models of tractors. We stock parts for the following brands: Allis Chalmers, John Deere, CaseIH, Kubota, David Brown, Mahindra, Deutz-Fahr, Massey Ferguson, Farmall, Minneapolis-Moline, Fendt, New Holland, Fiat, Oliver, Ford, White, International Harvester , Yanmar, J. MyTractorParts is a major North American Distributor for Aftermarket Tractor Parts including Filters, Engine part, engine kits, front end parts, tie rods, cylinders, pins, seal kits, rims, wheel hubs, axle parts, bearings, transmission gears/shafts, operator station parts, seats, PTO, hydraulic / steering / water pumps, radiators, oil coolers, hay balers parts. Plough tools, rake teeth, alternators, starter and more!! MyTractor is an aftermarket supplier for John Deere®, Perkins®, Caterpillar®, Yanmar®, Cummins®, Kubota®, Mitsubishi®, Shibaura® and International Harvester®/Navistar®.

All rights are reserved by these companies. MyTractor is NOT an OEM supplier and does not represent these companies.

All names, trademarks and part numbers are used for descriptive and identification purposes only. The item "Made to Fit FORD 12 VOLT CONVERSION KIT 2000 3000 4000 600 700" is in sale since Saturday, June 11, 2016. This item is in the category "Business & Industrial\Heavy Equipment, Parts & Attachments\Heavy Equipment Parts & Accessories\Other Heavy Equipment Parts & Accessories". The seller is "mytractorparts" and is located in USA. This item can be shipped to United States, Canada.

Brand: A&I
MPN: AKT0002
Model: 2000, 3000, 4000, 600, 700, 800, 900
Type: Ford Tractor Parts
Equipment Make: Ford
Equipment Type: Tractor
UPC: 0604716700546